Added Terasaki MCCBs to the Cable Size Calculator
|
Hi Reader I am just letting you know. I have added Terasaki (NHP) MCCBs to the Cable Size Calculator. It includes the A and P range (up to 630A), with thermal-magnetic trip units. Please let me know if you need electronic trip units or MCCBs with a higher current rating. Note that I have made some adjustments to the let-through energy curves. The calculator now reads from continuous curves instead of using fixed points, which should result in slightly lower let-through energy values. Please let me know if you have any questions or suggestions. I appreciate your feedback. Adam van Staden This information does not constitute legal, professional or commercial advice. JCalc Pty Ltd gives no guarantees, undertakings or warranties in this regard, and does not accept any legal liability or responsibility for the content or the accuracy of the information so provided, or, for any loss or damage caused arising directly or indirectly in connection with reliance on the use of such information. |
Subscribe to jCalc updates
One email per month.
Hi Reader Just letting you know. I added an Export Limit to the Voltage Rise Calculator. Let me know what you think. Click to try. Adam van StadenLinkedIn Profile This information does not constitute legal, professional or commercial advice. JCalc Pty Ltd gives no guarantees, undertakings or warranties in this regard, and does not accept any legal liability or responsibility for the content or the accuracy of the information so provided, or, for any loss or damage caused arising directly or...
Hi Reader Just letting you know. I added a new Voltage Rise Calculator for solar installations. Let me know what you think. Click to try. Adam van StadenLinkedIn Profile This information does not constitute legal, professional or commercial advice. JCalc Pty Ltd gives no guarantees, undertakings or warranties in this regard, and does not accept any legal liability or responsibility for the content or the accuracy of the information so provided, or, for any loss or damage caused arising...
Hi Reader I am just letting you know. I added two options to optimise the earth cable sizing for high current installations in the Cable Size Calculator. Option: Ignore table 5.1 sizes Ignore earth sizes specified in Table 5.1 in AS/NZS 3000. Earth size will be based on fault current and loop impedance only. This option is available when: Parallel single-core cable groups are used. Check fault rating and Check loop impedance are enabled. The calculated earth size is ≥ 120 mm2 (copper) or ≥...